- $9.95 flat shipping
- Fitment check
- Ask ReV
// motorcycle parts
Drivetrain
Clutch, Sprockets, Chains, Drive and more.
3,251 products in 8 categories, 3,018 in stock.
A motorcycle drivetrain carries power from the crankshaft to the rear wheel: primary drive, clutch, transmission, then final drive by chain, belt or shaft. This department covers the parts that wear and need regular replacement, including chains, sprockets, drive belts, clutch plates and the bearings and seals around them. Chain pitch, sprocket tooth counts and belt width are bike-specific, so start with your model.
Shop Drivetrain
How to choose
- Replace the chain and both sprockets together; a new chain on worn sprockets wears out quickly and can skip under load.
- Read the chain size before ordering: the first digit gives pitch in eighths of an inch, so 520, 525 and 530 share pitch but differ in width.
- Changing sprocket tooth counts alters gearing: fewer teeth up front or more at the rear gives quicker acceleration and lower top speed.
- For belt-drive V-twins, match belt width and tooth count to your pulleys, and check the pulleys for hooked or worn teeth.
- When a clutch slips or drags, replace friction plates, steel plates and springs as a set rather than one part at a time.
Common questions
What is a motorcycle drivetrain?
It is everything that moves engine power to the rear wheel. That includes the primary drive and clutch, the transmission gears, and the final drive, which is a chain and sprockets, a toothed belt and pulleys, or a driveshaft. The bearings, seals and covers that support those parts belong to it too.
Do you need to change sprockets with a chain?
Usually yes. A chain and its sprockets wear together, and a new chain on hooked or thinned sprocket teeth wears quickly and can skip. If the old chain was replaced early and the sprocket teeth are still square and even, some riders reuse them, but fitting all three together is the safe choice.
Which motorcycle drivetrain is best?
It depends on the bike and how you ride. Chains are light, efficient and easy to regear but need regular cleaning, lube and adjustment. Belts run clean and quiet with little upkeep and are common on V-twins. Shafts need the least routine care and suit touring bikes, but they add weight.









