// engine parts

Motorcycle Engine Parts

Top end and bottom end, gaskets, rebuild kits, covers and cooling — pick your bike to see the parts listed for it.

2,549 products from 154 brands.

Everything inside and bolted to the engine lives here, sorted into sub-departments by part, from piston kits and valves to crank bearings, gasket sets and radiators. Start by deciding whether the job is a top end, a bottom end or a full rebuild, then pick your motorcycle, dirt bike or ATV by year, make and model to see parts listed for it.

Shop by category

Shop by your bike — show only the products listed for it.Pick your bike

Shop by brand

Also in engine parts: Pushrods & Lifters

2,549 results

How to choose

  • Confirm whether your engine is a 2-stroke or 4-stroke and its exact displacement, since piston kits, gaskets and cams are made for one engine.
  • Match the job to the symptom: low compression or smoke usually points to the top end, while a deep knock or crank play points to the bottom end.
  • Order a full gasket kit with any rebuild, because used gaskets and O-rings rarely seal a second time.
  • On V-twins, note the engine family, such as Evolution, Twin Cam or Milwaukee-Eight, since covers, cams and hardware differ between them.
  • Have the service manual and a torque wrench ready before you open the engine; clearances and torque values decide whether a rebuild lasts.

Common questions

How do you clean motorcycle engine parts?

Use a parts washer or a degreasing solvent, a soft brush and plastic scrapers, then dry the parts with compressed air. Avoid wire wheels and abrasive pads on sealing surfaces, pistons and bearing journals. Keep blasting media out of oil passages, and lightly oil steel parts after cleaning to stop rust.

What is a motorcycle engine rebuild?

It means taking a worn engine apart, measuring the wear parts against the service manual and replacing whatever is out of spec. A top end job covers the piston, rings, cylinder and, on a 4-stroke, the valves. A full rebuild also splits the cases for the crankshaft, rod, main bearings and seals.

How long does a motorcycle engine rebuild take?

It depends on the job and your experience. A single-cylinder dirt bike top end often takes a home mechanic an afternoon to a day. A full rebuild takes several days of work, and machine shop jobs such as boring, replating or truing a crank add waiting time on top of that.