Trask Bro Bar (1 of 2)1 of 2

Trask

Bro Bar

1″ (25.4 mm) clamp diameter

Item # 0601-5194 · MFR # TM2093CH

$469.95
How to check your bar size
  • Measure the outside of your handlebar where the grip goes: calipers, or wrap a strip of paper around it and divide its length by 3.14.
  • 7/8″ (22 mm) is the usual size on metric street, sport, dirt and ATV bars.
  • 1″ (25.4 mm) is the Harley-Davidson size, used by most US cruisers too.
  • Fat (tapered) bars are 1-1/8″ (28.6 mm) at the clamp but still 7/8″ where the grips go — they take 7/8″ grips.

Fits 6 models, including:

Or check your bike

Sold out

Ships for $9.95 flat · lower 48

Shipping & returns

Questions about fit or sizing? Ask ReV

The Trask Bro Bar is a chrome steel H-bar for riders who want a tall, dramatic bar with a lot of reach. It is a 1" diameter bar with 1" clamping and controls areas, built from .120 wall tubing, and it carries a chrome finish over the steel.

The numbers are bold: an 18" rise (with 18" end rise) and 16" of pullback. The bar has a knurled center, aggressive knurling meant to minimize slipping, and a dimpled surface that is pre-drilled for internal wiring, so the harness can run inside the bar. It is sold as a single bar and listed for street riding. Expect that a bar this tall may need longer cables, brake lines and wiring, so plan for that with the install. It suits riders who want a standout, ape-style presence without going to a one-piece bend.

  • Made from .120 wall tubing
  • Aggressive knurling for minimal slipping
  • Dimpled and pre-drilled for internal wiring

6 models

Controls Diameter1"
FeaturesInternal Wiring / Pre-Drilled / Knurled Center
StyleDimpled
Base ColorSilver
Riding StyleStreet
Pullback/Sweep16"
Rise18"
Handlebar Diameter1"
MaterialSteel
FinishChrome
Clamping Diameter1"
Color/FinishChrome
End Rise18"
Type/BendH-Bar
Dimensions (L × W × H)40" × 22.5" × 8.75"
Weight13.9 lb
More from TraskThe Trask lineup compared, sizing, parts by bike and FAQ