Moose Offroad Spark Plug Resistor Cover (1 of 2)1 of 2
Moose Offroad

Spark Plug Resistor Cover (10M1302H)

Item # 2104-0455 · MFR # 10M1302H

Non-resistor

$9.95each

Free members earn $0.10, Gold $0.50, Elite $1.00 in CBC credit. Membership

In stock — ready to ship

Check if it fits your bike

How many plugs?

Check how many your engine takes: one per cylinder on most bikes (2 for twins, 4 for inline-fours). Twin-spark heads take two per cylinder.

Ships for $9.95 flat · lower 48

Shipping & returns

Questions about fit or sizing? Ask ReV

MOOSE OFFROAD's Spark Plug Resistor Cover is a replacement cap that fits onto the terminal of a spark plug wire, made to take the place of NGK resistor covers. The body is black plastic, and inside it is a ceramic resistor rated at 5 ohms. The cap is waterproof, which helps keep moisture away from the connection when you ride through wet conditions or wash the bike.

A T-type version with a T-shaped connector angle is also offered. Each cover is sold individually and is set up for a terminal nut configuration. It is listed for 14 mm spark plugs, and the thread size is adaptable. The cap accepts wire with a diameter of 7 mm to 8 mm, so measure your plug wire before ordering to confirm it falls in that range. It is listed for street riding. If your current NGK-style cap is cracked, worn, or no longer seals well, this is a straightforward swap, but check the variant name and your plug and wire details to make sure you pick the right one.

  • Replaces NGK resistor covers
  • Ceramic resistors that ensure performance
  • Adaptable thread size
  • 5 ohm resistance
  • Waterproof caps for superior performance
  • Allowable wire diameter 7 mm - 8 mm

ResistorSpark Plug
Connector AngleElbow / 90°
Compatible Spark Plug Size12 mm / 10 mm
Wire Diameter7 mm - 8 mm
Compatible Terminal ConfigurationTerminal Stud
MaterialPhenolic Resin
Weight0.1 lb
Manufacturer part #10M1302H

Installing spark plugs

  1. Work on a cold engine. Blow debris out of the plug well before removing the old plug.
  2. Check the gap with a wire gauge against your service manual; adjust gently on the ground electrode only.
  3. Start the new plug by hand for a few turns so it can't cross-thread.
  4. Tighten to the torque in your manual (or the angle printed on the box).
  5. Refit the plug cap until it clicks, and route the wire as it was.
  6. Replace plugs as a set, one per cylinder.
More from Moose OffroadThe Moose Offroad lineup compared, sizing, parts by bike and FAQ