// brakes

Motorcycle Brake Hardware & Fittings

Banjo bolts and fittings, pad pins, bleeders, crush washers and adapters.

166 products from 32 brands.

Small parts keep a motorcycle brake system sealed, and they are easy to lose or damage during a pad change or a line swap. This page lists banjo bolts and fittings, line adapters and tees, pad pins and clips, bleeder screws and caps, and the crush washers that seal every banjo joint. Check thread pitch and banjo size against the parts you are replacing.

Shop by your bike — show only the products listed for it.Pick your bike

Shop by brand

153 results

How to choose

  • Fit new crush washers every time a banjo bolt comes out; used washers are already flattened and may not seal again.
  • Match banjo bolt thread pitch and length to the part it threads into, since the wrong pitch can strip an aluminum caliper.
  • Bleeder screws with a built-in check valve make bleeding alone easier, but they must match the caliper thread.
  • Replace corroded pad pins and clips with new pads so the pads slide freely and wear evenly.

Common questions

Can you reuse motorcycle brake crush washers?

It is not a good idea. Copper and aluminum crush washers deform to seal the banjo joint, and a used washer may not seal again even when tightened harder. New washers are a small part next to a leak or air in the system, so fit fresh ones whenever a banjo bolt is removed.

What size are motorcycle banjo bolts?

Many modern motorcycles use a 10 mm banjo bolt, but thread pitch, length and single or double banjo stacks vary by model and by part. Check your old bolt or the listing for your bike before you order, and use the washers made for that bolt size.

What does a brake bleeder screw do?

The bleeder screw on a caliper or master cylinder opens a small passage so you can push old fluid and air out of the system. Keep it closed whenever the lever or pedal is released during bleeding. A rounded or seized bleeder should be replaced before the next fluid flush.