- $9.95 flat shipping
- Fitment check
- Ask ReV
// clutch & belts
Motorcycle Clutch Parts & Drive Belts
Clutch kits, friction and steel plates, springs, baskets, cables and lines, CVT clutch parts and drive belts from Barnett, Rekluse, EBC, Hinson, EPI, Gates, Belt Drives Ltd. and more. Pick your bike and we'll only show parts that fit it.

A slipping or grabbing clutch usually comes down to worn friction plates, tired springs or a damaged basket, and each is sold here separately or as a complete kit. You will also find cables, CVT clutch parts and belts for ATVs, UTVs and scooters, plus final drive belts and pulleys for belt-drive motorcycles.
740 products
Full kit, plates or springs?
- Clutch Kit
- Everything for a full rebuild (frictions, steels and springs), or an auto-clutch kit such as Rekluse.
- Plate Set
- Frictions and steels together — the usual fix for a slipping clutch.
- Friction Plates
- The fibre plates that wear; replace as a set when they're under spec or glazed.
- Steel Plates
- The steel drive plates between the frictions; replace when warped or blued.
- Clutch Springs
- Heavier or stock-rate springs — the cheap cure for slip on a strong engine; expect a firmer lever.
- Basket & Hub
- Clutch baskets, inner hubs and pressure plates — notched baskets cause a grabby, clunky clutch.
- Clutch Cables & Lines
- Clutch cables and hydraulic clutch lines — stock length or longer for taller bars.
- Cable & Hydraulics
- Cables, hydraulic lines, slave and master cylinders and levers.
- Covers & Guards
- Clutch covers, derby covers and guards.
- CVT Clutch Parts
- ATV, UTV and snowmobile primary / secondary clutch springs, weights, rollers and kits.
- Drive Belt
- CVT belts for ATVs, UTVs and sleds, and primary / rear drive belts for belt-drive bikes.
- Pulleys & Belt Drives
- Pulleys, open belt-drive kits and belt guards.
Clutch parts are engine-specific — the 'Fits your bike' badge only shows parts listed for your bike. Wet clutches need oil rated JASO MA / MA2.
Shop Clutch & Belts by brand
How to choose
- Measure friction plate thickness and spring free length against your manual's service limits, so you replace only what is worn.
- Replace springs whenever you fit new friction plates, and check steel plates for warping or blue heat marks.
- Inspect the basket fingers for notches; a notched basket makes the clutch drag or engage unevenly even with new plates.
- Stiffer springs resist slip on a modified engine but raise lever effort, so stay with standard rate on a stock bike.
- Match CVT and final drive belts by part number, or by measured length, width and tooth count, since belts that look alike can differ.
Common questions
What does motorcycle clutch slipping feel like?
Engine revs rise when you open the throttle but the bike doesn't accelerate to match, most noticeably in higher gears or under hard load. Slip usually comes from worn friction plates, weak springs, the wrong oil, or a cable adjusted with no free play, so check free play first.
Do motorcycle clutches use engine oil?
Most four-strokes do: the wet clutch shares the engine oil, which is why that oil should meet JASO MA or MA2 rather than car oil with friction modifiers. Two-strokes run the clutch in separate gearbox oil, big twins like Harley-Davidson use primary case oil, and a few bikes have a dry clutch.
Do motorcycle clutches wear out?
Yes. Friction plates wear thinner with every engagement, springs lose tension and steel plates can warp or glaze from heat. How fast depends on riding: slipping the clutch off-road or in traffic wears it far faster than highway miles. Measure plates against your manual's service limits once it starts slipping.
