// frenos

Frenos para moto

Pastillas, discos y pinzas, líneas de freno, cilindros maestros, líquido de frenos y tornillería. Elige tu moto para ver qué le queda.

496 productos de 73 marcas.

Most motorcycles stop with hydraulic disc brakes: the lever or pedal pushes fluid through a line to a caliper that clamps pads onto a rotor. This department covers every part of that system, from sintered and organic pads to braided lines, rebuild kits and banjo bolts. Pick your bike first, since pad shapes, rotor sizes and caliper mounts differ by model.

Comprar por categoría

Comprar por tu moto — muestra solo los productos listados para ella.Elige tu moto

Comprar por marca

475 results

Cómo elegir

  • Match pads to your riding: sintered pads suit heavier bikes, wet weather and hard use, while organic pads run quieter and are gentler on rotors.
  • Measure rotor thickness against the minimum stamped on the rotor before fitting new pads; a rotor at or under that limit needs replacing too.
  • Stainless braided lines resist swelling better than aged rubber hoses, which gives a firmer lever; check the length and banjo angles listed for your model.
  • Use the brake fluid grade printed on your master cylinder cap, and never put DOT 5 silicone fluid in a system built for DOT 4.
  • A caliper or master cylinder rebuild kit restores seals and pistons without replacing the whole unit, as long as the bore is clean and unpitted.

Preguntas frecuentes

Are motorcycle brake pads universal?

No. Pads come in many backing-plate shapes, sizes and pin layouts, and each one is made for specific calipers. Many bikes even use different pads front and rear. Pick your bike to see the pads listed for it, or match the pad number printed on the pads you are replacing.

Does motorcycle brake fluid go bad?

Yes. DOT 3, 4 and 5.1 fluids absorb moisture from the air over time, which lowers the boiling point and can corrode internal parts. Many manufacturers call for a flush every one to two years. Dark or cloudy fluid in the reservoir is a sign it is due.

Can motorcycle brake rotors be resurfaced?

Generally no. Motorcycle rotors are thin, and most have a minimum thickness stamped on them that leaves little or no room for machining. A rotor that is warped, deeply scored or worn under the minimum should be replaced. Light surface glaze can often be removed with a scuff and fresh pads.